Publicidad
Idiomas disponibles
Idiomas disponibles
Telescoping Handle
Congratulations on your purchase of this Extech Telescoping Handle. This accessory can be used
with several Extech meters to enable measurements in areas normally unreachable.
Operation
The meter sensor is attached to the top of the pole using the tripod screw.
1.
Release the head cover (3) by pressing the two release
latches (1).
2.
Secure the meter to the head tripod screw (2) and replace the
head cover
3.
Adjust the head to the needed angle and tighten with the
locking screw (4)
Extend the pole sections by twisting the locking nuts as shown and then securing at
the desired length.
NOTE: The extended pole should only be used in the vertical position. If
used in the horizontal position with the pole extended the meter's weight
will damage the mechanism.
Specifications
Length
Weight
Adjustment rings
Shafts
Copyright © 2011 Extech Instruments Corporation (a FLIR company)
All rights reserved including the right of reproduction in whole or in part in any form.
EXT-1: Extended; 1.3m (4 ft), Collapsed; 0.47m (1.5ft)
EXT-3: Extended; 3.2m (9.8ft), Collapsed; 1m (3.3ft)
EXT-5: Extended; 5.2m (16.4ft), Collapsed; 1.5m (4.9ft)
EXT-1: 386g (0.85lbs.)
EXT-3: 703g (1.55lbs.)
EXT-5: 998g (2.2lbs.)
Polycarbonate with infused fiberglass
Iodized black extruded aluminum
www.extech.com
2
1
4
EXT-1-3-5-EU-V1.0 11/11
2
3
1
Publicidad
