BaByliss E770XDE Manual De Instrucciones página 5

E N G L I S H
E S C R I P T I O N O F T H E C L I P P E R
A N I T S A C C E S S O R I E S
1. Cutting guide
2. Precision cutting guide for extre-
mely short cutting lengths: 0.5, 1,
1.5, 2 and 2.5 mm.
3. Blades:
Moving cutter:
- Three-dimensional
process: exceptional sharpness.
- Organic CARBON HLD* (Hard
Like Diamond) coating with hard-
ness close to diamond's: 100%
stainless ultra strong cutter
Fixed cutter:
- Titanium coating: unbeaten dura-
bility
The association
technologies perfects the surface
of the blades reducing the coeffi-
cient of friction and the adhesion.
Lubricating is no more needed.
The motor's cutting power is totally
released.
4. Turbo
5. On/off switch
6. Lead for corded operation and
charge
7. Scissors
8. Comb
9. Lubricating oil
10. Cleaning brush
11. 1 pouch (models E760XDE
and E765XDE) /
1 case (model E770XDE)
12. 1 shoulders protection cape
(model E770XDE)
C H A R G I N G
Ensure that the clipper is switched
off. Insert the small plug firmly into
the clipper, then the mains plug
into the wall socket. The charging
indicator lamp will light up to indi-
cate that charging has begun. After
16 hours, the clipper will be fully
charged. A full charge will supply
enough power for about 1H.
Charge the clipper for 16 hours
before the first use.
To keep the batteries in good con-
dition, avoid charging the clipper
too frequently.
etching
C O R E O P E R A T I O N
Insert the small plug into the clip-
per, then the mains plug into the
wall socket. Wait for about a minu-
te then switch on. Do not use the
clipper in this mode for more than
30 minutes.
T U R B O F E A T U R E
For an extra burst of power, push
of these
the "Turbo" button on the top side
of the clipper. This will boost the
motor of your clipper, producing
faster cutting action and increased
cutting power for the more difficult
cutting tasks.
U S E O F T H E C U T T I N G G U I E S
IMPORTANT
the cutting guide on the clipper
BEFORE switching the clipper on.
Always switch the clipper off to
change the cutting guide.
The cutting guides provide you an
even cutting length.
The clipper comes with 5 cutting
guides offering 17 cutting lengths:
N°1
N°2
N°3
N°4
N°5
To install a cutting guide, insert
the two lugs at the bottom of the
: Always
3-6-9 mm
12-15-18 mm
21-24-27 mm
30-35-40 mm
"Precision" cutting guide:
0.5-1-1.5-2-2.5 mm
place
5