Polaroid XS100 Manual Del Usuario página 9

POLAROID XS100 USER GUIDE
Camera Mounting Methods
The XS100 versatile Mount-Lock Mounting System allows you to use your XS100 in all types of scenarios. With the
included helmet and handlebar mounting systems it allows you to attach to all types of helmets like bike (vented),
motorcycle, ski, skydive, white water rafting etc. or mount on to a handlebar of a bike, jet ski, 4x4 ATV, Motorcycles as
well as Ski poles. The Mount-Lock system allows you to easily remove and remount the camera. Visit Polaroidaction.com
for additional exciting mounting systems.
Secure String with Quick Disconnect
to feel more secure, a Secure String is included.
1. Loop one end of the secure strap through the strap hole of the camera. You may use a pin to help thread it through
the hole.
2. Attach the other half to the mount you are using in the strap hole or to any other secure place.
3. Clip both ends when camera is mounted.
Attaching Mount-Lock to the XS100
1. Fit the screw of the Mount-Lock in to the tripod socket of the
camera.
2. Turn the Mount-Lock screw until it is tightened. You can do it by
hand using the built-in triangular wire wrench or with the Mount-
Lock key; the Mount-Lock Release Arms should now be facing the
front of the camera.
All manuals and user guides at all-guides.com
16
Installing the Helmet Straps into the Helmet Mount
1. Choose the suitable strap to mount on different types of helmets. For
example, use the short mount strap for bike helmets and the medium
mount strap for motorcycle helmets.
2. Remove the two strap clips from the strap.
3. There are three vents at each side of the Helmet Mount. Loop the
strap through the inner vent (closest to the center) from the bottom.
(Step 1)
4. Loop the strap through the strap clip from the top. (Step 2)
5. Loop the strap through middle vent from the top. (Step 3)
6. Loop the strap through the outer vent from the bottom (Step 4)
7 . Tighten the strap and repeat Steps 1-4 on the other side.
Mounting Helmet Mount on a Vented Helmet
1. Choose the Helmet Mount with the suitable length of strap.
2. Adhere the single-sided adhesive mount to the base of the helmet
mount. Use the double-sided adhesive mount to permanently secure
the mount to the helmet.
3. Loosen and detach the ball joint nut from the helmet mount.
4. Insert the Ball Joint through the Ball Joint Nut and then into the Mount
Socket, and you should hear a loud click, then tighten the Ball Joint
Nut.
5. Loop the strap of the helmet mount through the vents of the bike helmet and back through the strap clip.
6. Fasten the strap.
7 . Repeat on the opposite end of the strap until the Helmet Mount is firmly attached to the helmet.
8. Attach the Mount-Lock and camera into the Ball Joint Socket. Assure that the Mount- Lock Ball Joint Nut is
tightened securely.
9. The ball joint system allows you to change the angle of the camera. Simply loosen the nut, adjust the camera angle
and re-tighten the nut.
Mounting Helmet Mount on a Non-Vented Helmet (Motorcycle)
1. Adhere the Helmet Mount to the helmet by applying a double-sided 3M® adhesive mount. By utilizing a
combination of the Helmet Mount and fitting piece with straps; it will provide additional security to the mounting
POLAROID XS100 USER GUIDE
17