Publicidad
Idiomas disponibles
Idiomas disponibles
SPE C IF I CAT I ON S
Installation Requirements
7
A minimum
/
"
is required from the bottom of the unit to
(22)
8
any material.
Clearance is required for the conduit located at the right rear
of the unit. Refer to the illustration below for dimensions.
Refer to the illustration on the following page for minimum
clearances.
WARNING
Failure to locate the unit without proper clearances will
result in a fire hazard.
1
"
1
/
4
(32)
1
"
2
/
2
1
"
2
/
2
(64)
(64)
Conduit clearance.
|
4
Wolf Customer Care 800.222.7820
Electrical
Installation must comply with all applicable electrical codes.
Locate the electrical supply as shown in the illustration
on the following page. A separate circuit, servicing only
this appliance is required. A ground fault circuit interrupter
(GFCI) is not recommended and may cause interruption of
operation.
Performance may be compromised if the electrical supply is
less than 240 volts.
When multiple cooktops or modules are installed side by
side, each unit must have its own separate recommended
electrical circuit.
Connection of this appliance should be
IMPORTANT NOTE:
through a fused connection unit or a suitable isolator, which
complies with national and local safety regulations. The
on/off switch should be easily accessible after the appli-
ance has been installed. If the switch is not accessible after
installation (depending on country) an additional means of
disconnection must be provided for all poles of the power
supply. When switched off there must be an all pole contact
gap of 3 mm in the isolator switch. This 3 mm contact dis-
connect gap must apply to any isolator switch, fuses and/or
relays according to EN60335.
E L E C T R I C AL R E Q U I R E M E N T S
Electrical Supply
grounded 3-wire, 240/208 VAC, 50/60 Hz
Service
Conduit
RATING
PLATE
Rating plate location.
15 amp dedicated circuit
flexible 4'
(1.2 m)
Publicidad
