Setup; Step 1: Connect Your Monitor To Your Computer; Step 2: Connect The Power Cord - Sony CPD-E500 Manual De Instrucciones

Setup

Before using your monitor, check that the following accessories
are included in your carton:
• Power cord (1)
• Macintosh adapter (for beige system) (1)
• Setup Disk (1)
• Warranty card (1)
• Notes on cleaning the screen's surface (1)
• This instruction manual (1)
Step 1: Connect your monitor to
your computer
Turn off the monitor and computer before connecting.
Note
Do not touch the pins of the video signal cable connector as this might
bend the pins.
x Connecting to an IBM PC/AT or compatible
computer
AC IN
to video output
IBM PC/AT or compatible
computer
6
x Connecting to a Macintosh or compatible
computer
AC IN
Macintosh adapter (for beige system)
(supplied)*
to video
Macintosh or
output
compatible computer
* Connect the supplied Macintosh adapter to the computer before
connecting the cable.
This adapter is compatible with Macintosh LC, Performa, Quadra,
Power Macintosh, and Power Macintosh G3 series computers that have
two rows of pins. If you are connecting to the other version of Power
Macintosh G3 series with three rows of pins or models other than those
stated above, you will need a different adapter (not supplied).

Step 2: Connect the power cord

With the monitor and computer switched off, first connect the
power cord to the monitor, then connect it to a power outlet.
AC IN
to AC IN
power cord (supplied)
to a power outlet