Leg Installation - BOCCHI LAVITA 1168 Serie Instrucciones De Instalación

Leg Installation

• Apply a small bit of silicone sealant to the floor in the marked
area where each leg will be set.
• Apply a small bit of silicone sealant to the top of each leg as
shown in the picture.
• Gently tip the sink upwards and set the legs into place by fitting
the notch on the top of each leg into the matching space on the
underside of the sink.
• Set the legs into the correct spot on the floor and ease the sink
back into position with the legs in place.
• Gently clean any excess silicone from around the
base of the feet so that the floor is clean.
• Level the sink and use the adjustable wrench, or a standard 13mm
wrench, to tighten the nut onto the bolts.
CAUTION: DO NOT overtighten!
• To create a strong bond with the sealant, do not
bump or push against the legs for 24 hours.
4
www.BOCCHIUSA.com