Care And Maintenance - Uline H-5163 Manual Del Usuario

Figure 2
Figure 3
Figure 4
Figure 5
1. Clean the table with a cleaner/brightener that
contains mildewcide.
PAGE 2 OF 6
ASSEMBLY
5. Place the preassembled table top upside down.
6. Pre-drill four holes using 1/8" drill bit. Loosely attach
7.
8. Flip the table so it is right side up.
9. Make sure legs are level and tighten all 3½" carriage
10. Attach a seat brace along the center of two seat
11. Place the outside edge of the seat bench flush with

CARE AND MAINTENANCE

2. It is recommended to apply an outdoor wood
1-800-295-5510
uline.com
Position the legs on the inside mount of the support
bar. Make sure the legs are equal distance from either
table edge and the cross-member is facing out.
(See Figure 2)
legs using four 2½" wood screws. Repeat steps to
attach the other leg.
Make sure the legs are perpendicular to the table
top to ensure table top is level. Pre-drill holes using
1/8" drill bit and attach diagonal braces using
four 2½" wood screws to the cross-member and
preassembled table top. (See Figure 3)
bolts using a 7/16" socket wrench. Tighten all 2½"
wood screws.
planks ensuring the brace is equal distance from
both ends of the seat. Pre-drill holes using 1/8" drill bit
and attach using ten 2½" wood screws on the brace.
Repeat for the second seat plank. (See Figure 4)
the ends of the seat braces and align the ends of
the bench with the edge of the table top. Use a 1/8"
drill bit to pre-drill holes. Attach the seat bench to the
braces using eight 2½" wood screws per bench seat.
Repeat for opposite seat bench. (See Figure 5)
sealer or stain that contains water repellent and
an ultraviolet stabilizer. Table must be dry before
applying.
0621 IH-5163