Publicidad
en
Make sure that the item is installed by a competent
installer.
Shut off the main water supply.
Observe all local plumbing and building codes.
Do not fit any form of flow control in the outlet pipe
work if the shower fittings are installed in conjunction
with a product that requires the fittings to act as a
vent (e.g. an electric shower).
The position of the shower and shower fittings must
provide a minimum gap of 25 mm between the
showerhead and the spill over level of any bath,
shower tray or basin and a minimum gap of 30 mm
between the showerhead and the spill over level
of any toilet, bidet or other appliance with a Fluid
Category 5 backflow risk (see diagram).
Mixer
Shower
30 mm
Minimum
25 mm Minimum
Bath or Shower
Toilet or Bidet
FC5
SPECIFICATION
M i n i m u m m a i n t a i n e d
pressure
M a x i m u m m a i n t a i n e d
pressure
Maximum recommended
temperature
1235741-W2-A
GENERAL
Zone of
25 mm
Minimum
Hand Basin
Tray FC3
FC3
0.2 bar (20 kPa)
3.0 bar (300 kPa)
60°C
fr
GÉNÉRALITÉS
Assurez-vous que l'élément est installé par un
personnel compétent.
Couper l'alimentation d'eau principale.
Respecter tous les codes de plomberie et de
bâtiment locaux.
SPÉCIFICATIONS
P r e s s i o n
m i n i m a l e
maintenue
P r e s s i o n m a x i m a l e
maintenue
Température maximale
conseillée
de
Die Montage, darf nur durch einen geeigneten
Fachmann durchgeführt werden.
Schließen Sie den Hauptwasseranschluss.
Beachten Sie die geltenden Vorschriften für
Klempner-und Bauarbeiten.
TECHNISCHE DATEN
Mindestdruck
Höchstdruck
Empfohlene Höchsttem-
peratur
es
Asegúrese de que el componente es instalado por
personal competente.
Cierre la llave principal de agua.
Respete las normativas locales de fontanería y
construcción.
ESPECIFICACIÓN
Presión mantenida mínima 0,2 bar (20 kPa)
Presión mantenida máxima 3,0 bar (300 kPa)
Temperatura máxima
recomendada
8
0.2 bar (20 kPa)
3.0 bar (300 kPa)
60°C
ALLGEMEIN
0,2 bar (20 kPa)
3,0 bar (300 kPa)
60°C
GENERAL
60°C
Publicidad
