Troubleshooting - POLTI Vaporetto SV660_STYLE Manual De Instrucciones

21. TROUBLESHOOTING

PROBLEM
The appliance does not turn
on.
No steam is coming out.
In steam mop setting the ap-
pliance doesn't work.
The appliance releases too
much water on the floor
The metallic tube cannot be
pulled out.
Polti Frescovapor deodoriser
is not released when using
steam.
(only for Polti Vaporetto
SV660/650/620_STYLE
models)
Steam too damp using Polti
Frescovapor.
(only for Polti Vaporetto
SV660/650/620_STYLE
models)
Should the problem persist or if it is not in the table, contact an Authorised Polti Service Cen-
tre (see www.polti.com for the up-to-date list) or Customer Services.
POSSIBLE CAUSE
No power.
Out of water.
Appliance turned off.
The metal tube is not proper-
ly in-serted.
Steam output control set to
the maximum.
The power cord not unwound. Check that the power cord
Deodoriser selector in OFF
position.
Deo Dispenser door open.
Check the Polti Frescovapor
level.
The steam is mixing with Polti
Frescovapor.
31
SOLUTION
Check that Polti Vaporetto
has been connected to the
mains as shown in Chapter 1.
Disconnect the appliance
from the mains, fill the water
tank and wait about 15 sec-
onds, then use the appliance.
Check that the appliance has
been disconnected from the
mains, as indicated in Sec-
tion 1.
Insert the metal tube into the
rectangular opening until you
hear the coupling "click".
Reduce the steam intensity
to the minimum. If necessary,
momentarily stop the steam
supply while continuing to
rub the surface.
has been unwound from the
special cord-winder hooks.
Push the selector.
Carefully close the Deo Dis-
penser door.
Fill the dispenser with Polti
Frescovapor.
Stop the Polti Frescovapor
supply as desired to reduce
the humidity of the steam.