Publicidad
Idiomas disponibles
Idiomas disponibles
TEST RUN
- Start the tool and check that there is no unusual vibration or
dismatching of the abrasive disc. Otherwise, switch off immedia-
tely and eliminate the cause
WATER FLOW REGULATION
The flow of water is controlled by turning tap (7). Always shut-off
the water supply if the tool remains inactive. This is to prevent any
accidental penetration of liquid inside the motor. Should this happen,
unplug the tool immediately and thoroughly dry it using a jet of
compressed air on the body and motor ventilation slots (9). Do not
restart the tool until it is perfectly dry.
REMOVING AND REPLACING ABRASIVE DISCS
- Follow the instructions supplied by the abrasive disc manufacturer.
USABLE TOOLS
- Diamonded discs for wet sanding.
MAINTENANCE
All maintenance operations are carried out with the power supply
disconnected.
- At the end of each work session, or when required, remove any
dust from the body of the tool using a jet of compressed air, paying
particular attention to the motor ventilation slots.
No other maintenance operations must be undertaken by the
user. If necessary, consult an authorised Assistance Centre.
All manuals and user guides at all-guides.com
NOISE
The noise generated by the tool under normal operating conditions is
88.7 dB measured in accordance with standard EN 50144.
Take suitable precautions to protect hearing from possible
damage from noise generated by the tool.
MEAN ACCELERATION VALUE
The mean quadratic acceleration value is less than 2.5 m/sec
RADIO SUPPRESSION
The tools are suppressed in accordance with EC Directive 89/336 for
the prevention and elimination of radio disturbances.
GUARANTEE
All tools manufactured by RUPES SpA are guaranteed for 12 months
from the date of purchase against fabrication and material defects.
The guarantee will no longer be valid if the instructions contained in
this booklet are not followed, if the tool is used for purposes other than
that for which it is intended, if it is dismantled, interfered with in any
way or damaged due to neglect.
The guarantee will be made valid by filling-in the form on the
inside back cover of this instruction booklet.
If the tool is found to be defective or malfunctions, it should be
returned carriage free in one piece in its original packing together with
the guarantee certificate to the manufacturer or to one of the
Assistance Centres listed in the appendix to this booklet.
The guarantee does not automatically imply replacement of the tool.
RUPES reserve the right to carry out modifications to the tool without
prior notice.
2
.
7
Publicidad
