Install And Take Out Battery; Insert And Take Out Storage Card; Insert Storage Card; Take Out Storage Card - aqprox appHULKCAMPRO Guia Del Usuario

All manuals and user guides at all-guides.com
Picture 1

Install and take out battery

Please use the appropriate lithium-ion battery (above 3.7V 1800mAH), any inferior
batteries will severely damage the camera.
6) Open the back cover.
7) Open the battery slot door according to the direction of arrow.
8) Insert battery into the battery slot according to the polarity direction as shown
on the battery cover.
9) Close the battery slot door and twist the clasp according to the reverse
direction of arrow.
10) Unscrew the cover at the end of the unit and open the battery slot door,
according to the direction of arrow (to the right), turn the knob to open the
battery cover, and take out the battery.

Insert and take out storage card

3. Insert storage card

1) Open the camera back cover
2) Insert the card according to the direction as show
3) Close the cover
4. Take out the storage card
1) Turn off the camera and open the back cover.
2) Press the end of the storage card slightly, it will automatically eject.
3) Close the cover
Notice：
a) Before using the SD card, please check whether the key lock on it is locked;
b) Please confirm the inserting direction of the SD card because reversed
inserting may cause damage to the camera and the SD card;

Battery charging

Install the battery into the battery slot according to the above methods and close
the cover, then connect the charger to the USB port and plug in the power. During
charging, the red indicator on, when fully charged, the indicator off.
Notice:
a) In order to improve the charging efficiency, please charge the camera
under the shutdown status. (charging time is about 3hrs)
b) Please make sure the AC power is turned on when the charger is pluged.
picture 2 picture 3
25