Tabla de contenido
Publicidad
SAFETY, OPERATORS, MAINTENANCE & PARTS MANUAL
3
SAFETY INSTRUCTIONS
DANGER - Indicates an imminently hazardous
situation which, if not avoided, WILL result in death
or serious injury.
WARNING - Indicates a potentially hazardous
situation which, if not avoided, COULD result in
death or serious injury.
CAUTION - Indicates a potentially hazardous
situation which, if not avoided, MAY result in minor
or moderate injury and property damage. It may
also be used to alert against unsafe practices.
WARNING
Hydraulic Fluid escaping under pressure
can penetrate skin and do serious damage.
Immediate medical assistance must be
sought.
en-6
JACOBSEN FAIRWAY & T-PLEX CUTTING UNITS
IMPORTANT: Transport speed is for highway use
only. Never select transport speed on grass areas
or uneven or unsurfaced roads or tracks.
The operating Instructions for the Cutting Units are
contained in a separate Publication .
SAFETY, OPERATORS, MAINTENANCE & PARTS MANUAL
4
SPECIFICATION
CONSTRUCTION
Heavy duty welded pressed steel construction
CYLINDER:
Diameter:
165mm (6-1/2in)
Width of cut:
660mm (26in)
Number of knives:
7 and 11
Height of cut:
12mm - 47mm
(15/32in - 1-25/64in)
CUTTING CYLINDER TO BOTTOM BLOCK
ADJUSTMENT
Self locking notched hand micro adjusters. Each
notch giving 0.04mm (0.0015in) of movement.
HEIGHT OF CUT ADJUSTMENT
Front roll:
Threaded roll carriage &
locknuts.
Rear roll:
Coarse adjustment: Three
position housing mounting.
Fine adjustment:
Threaded roll
carriage &
locknuts
REAR ROLL
Full width 75mm (3in) diameter plain roll running
on taper roller bearings with shaft seals and
lubricators.
FRONT ROLL
Full width 75mm (3in) diameter grooved roll
running on taper roller bearings with shaft seals
and lubricators.
or
Full width 75mm (3in) diameter plain roll running
on taper roller bearings with shaft seals and
lubricators.
BOTTOM BLOCK & BLADE
Blade replaceable, mounted onto welded steel
constructed bottom block.
TRANSMISSION
By hydraulic motor through cardan shaft to cutting
cylinder.
JACOBSEN FAIRWAY & T-PLEX CUTTING UNITS
en -7
Publicidad
Tabla de contenido
