Troubleshooting Guide - DeWalt DCN680 Manual De Instrucciones

English
MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW. FOR MORE SERIOUS OR PERSISTENT
PROBLEMS, CONTACT A D

WARNING: To reduce the risk of serious personal injury, turn unit off and remove the battery pack before
making any adjustments or removing/installing attachments or accessories. An accidental start-up can
cause injury.
Symptom
Tool doesn't turn on Tool internal electronics not reset
(Headlights don't turn on)
Low battery charge or damaged battery
Terminals are dirty or damaged
Bent contact trip
Damaged internal electronics
Tool doesn't actuate (Headlights on, Motor stops running after 4 seconds
motor does not run)
Contact trip or trigger not depressed
Damaged trigger
Bent contact trip
Damaged internal electronics
Tool in sequential mode and only trigger being actuated.
Tool doesn't actuate (Left headlight Low battery charge or damaged battery
flashes 4 times)
Tool doesn't actuate (Right headlights Jammed fastener
flashes continuously)
Jammed mechanism
Tool doesn't actuate (Headlights on, Damaged internal electronics
motor runs)
Tool doesn't actuate (Headlights on, Damaged return system
motor runs, driver blade stuck down)
Debris in nosepiece
Damaged driver/return assembly
Tool operates, but does not drive the Low battery charge or damaged battery
fastener fully
Depth adjustment set too shallow
Tool not firmly applied to workpiece
Material and fastener length too rigorous an application
Damaged or worn driver blade tip
Damaged or worn driver/return assembly
Tool operates, but no fastener driven No fasteners in magazine
Wrong size or angle fasteners
Debris in nosepiece
Debris in magazine
Worn magazine
Damaged or worn driver blade
Damaged pusher spring
14
All manuals and user guides at all-guides.com

Troubleshooting Guide

WALT SERVICE CENTER OR CALL 1-(800)-4-D
e
Cause
WALT.
e
Fix
Remove battery, wait 3 seconds and reinsert
Charge or replace battery
See authorized service center
See authorized service center
See authorized service center
Normal operation; release trigger or contact trip and
redepress
See instruction manual
See authorized service center
See authorized service center
See authorized service center
Change mode or depress contact trip in
sequential mode.
Charge or replace battery
Remove the battery, clear the jammed fastener, (push
driver blade back using the stall release lever) and
reinsert battery pack
See authorized service center
See authorized service center
Replace return system; see authorized service center
Clean nosepiece
Replace driver/return assembly; see authorized service
center
Charge or replace battery
Rotate depth adjustment wheel to a deeper setting
See instruction manual
Choose appropriate material or fastener length
Replace driver/return assembly; see authorized service
center
Replace driver/return assembly; see authorized service
center
Load fasteners into magazine
Use only recommended fasteners
Clean nosepiece
Clean magazine
Replace magazine; see authorized service center
Replace driver/return assembly; see authorized service
center
Replace spring; see authorized service center