Electrolux DFW51 Manual De Instrucciones página 9

Removible Multi Use Drawers
Those 2 shelves serve to store
several types of food. Those shel-
ves can be assembled in several
positions in the refrigerator, but
they shall not be used in the
freezer door, because they obstruct its closing, as
indicated in the examples below.
Bottle Shelves and Locks
1. Bottle-holder Shelves:
The bottle-holder shelf accommo-
dates bottles of 3.3 liters.
2. Bottles lock:
The bottle lock has a function that
prevents bottles from shaking
loose on the shelf.
To use it, just fit it onto the shelf and slide it to the sides,
as shown on the figure.
It can also be used to store small condiments or in
its interior.
Removable Can Dispenser
This part was especially developed to
store cans with 350 ml of your favorite
drink. The cans may be assembled
in the support with the superior part
of the can directed to the center, first
inserting the bottom of the can on the
side of the support (1) and then in the
central part of the support (2), as the
illustration beside shows, otherwise,
the cans will fall.
You can remove the can compart-
ment and take it to the table for your
best convenience, to facilitate the
withdrawal pull the same direction
as shown in drawing (3). The can
compartment can be used in the
refrigerator and in the freezer. In it,
you can cool faster all the cans at
the same time, by only activating the
function "DRINK EXPRESS" in the Control Panel.
When it is assembled in the door of the refrigerator, and
without bearing cans, it can be used as a lock for the
bottles (4).
Water Container
Developed to provide pure and
healthy water, given its exclusive
filtering system.
Pure Filter
Fill it with potable water only and
wait the filtering to start.
How to Use the Water Container
1. Remove the container wi-
thout water from the refrige-
rator door, lifting and pulling
it according to the illustration
beside (1).
2. Remove the tap of the con-
tainer, rotating it counter-clo-
ckwise (2).
3. Push the cover in the (3) direction and fill up the
container with treated water and wait for the filtering.
We recommend the first filtering to be made in a
place where the filtered water can be discarded (for
example, in the sink).
Repeat this procedure 3 times (approximately 9 liters
of water).
This procedure shall be repeated every time you
change the refill (purifier). We recommend you to
change the refill every 6 months or 500 liters.
4. Mount the sealing rubber and the tap in the container.
ATTENTION
Be careful not to invert the
direction of the assembling of
the rubber part, according to
the illustration beside.
5. Fit the container without water in the refrigerator
door.
6. Push the cover of the superior part of the container,
fill it up and wait the water filtering process.
7. After this procedure, you can normally use the
filtering system.
8. To serve, open the dispenser, rotating it, put a glass
along with the water exit, located in the external part
of the refrigerator door and activate the button (A)
located right above it.
9. To avoid unwanted activation, turn the dispenser
and keep it closed (position 1).
A
9