Tabla de contenido
Publicidad
3.6 PoE power output
The tester supports PoE (Power over Ethernet) output to an IP camera via the LAN port. Data
transmission and POE 48V use the network cable's 1, 2, 3, and 6 pins to deliver power. If the IP
camera supports PoE, you can directly connect to the camera without the use of an external power
supply.
Notice
a. Please make sure the cable connected to the tester's Lan port is straight-line cable and has no short
circuit, otherwise will damage the tester
b. Before using PoE power output, pls check the IP camera whether supports POE powered. Otherwise
it will damage the IP camera.
c. The instrument's PoE maximum power output is 24W. If Ultra- high-power load happens, the tester
will enter protection mode .
3.7 DC12V 2A power output
When the IPC tester is turned on, the DC 12V power output ON by default. The smaller end of the
supplied converter cable connects to the tester's DC12V/2A OUTPUT and the other end connects to the
camera's power input.
Page.122.
Publicidad
Tabla de contenido
