Konig Security SEC-APR20 Instrucciones página 2

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 21
All manuals and user guides at all-guides.com
Battery installation:
Alarm Unit
1. The bazkus compartment is accessed from the rear of the alarm
unit by removing the back cover.
2. Insert 2x 'AA' size batteries (not included) conform the polarity as
shown in the battery compartment.
3. When the last battery is inserted the alarm will beep very loudly
to indicate that the batteries are installed properly.
4. Re-place the back cover again.
Remote Control
The remote control uses 1x A23S battery (included).
Note: The Battery Low indicator will light when the batteries needs
to be replaced. Do not mix different types of battery such as
Alkaline and Carbon-zinc or old batteries with new. Remove the
batteries if the alarm will not be used for a period of time.
Alarm installation:
1. Place the alarm in the desired location with the rotary wall mount
bracket.
2. Fix the bracket to the wall with the supplied screws.
Note: The alarm can also be used, without the bracket, as a free
standing alarm.
Operation:
1. Press, at a distance of 10 meter, the 'On' button of the remote
control. A confirmation tone will indicate that the alarm is armed and
you have 30 seconds to leave the projected area. After this time, if
motion is detected, the alarm will sound.
2. Press, when entering the protected area, the 'Off' button of the
remote control within a distance of 10 meter to disarm the alarm.
When entering the area, there is a short beep to indicate that
motion has been detected and you have a 4 second delay before
the alarm will sound.

Publicidad

Tabla de contenido
loading

Tabla de contenido