Bimar Caldi BW10RC Manual De Instrucciones página 6

Fax +39 030 9904733

the event of incompatibility between the electric outlet and the plug of the
appliance, have the outlet replaced with another more suitable type by
professionally qualified personnel, who will make sure that the section of the
wires of the outlet is appropriate for the absorbed power of the appliance. In
general, the use of adapters or extension cords is not recommended; if their use is
indispensable, they must conform to existing safety standards and their current
capacity (amperes) must not be less that the maximum of the appliance.
Before each use, verify that the appliance is in good condition and that the
electrical cord is not damaged: in the case of doubt, ask for professionally
qualified help.
Make sure that the cable is correctly positioned, that it is not touching hot
elements or sharp edges, is not wound around the utensil, is not twisted up on
itself or in the way to prevent the utensil from being pulled over.
Position the utensil far from other sources of heat, objects or anything else that
could come into contact with the hot parts. Check that the support surface is
stable and flat to prevent the utensil from tipping over.
Position the utensil far from liquid containers (washbasins for example, etc.), to
protect against water splashes or from falling into the same.
In the event of a breakdown or poor operation, turn the fan heater off and ask for
professionally qualified help.
UTENSIL DESCRIPTION
Initial use
Before using for the first time, clean the container with a damp cloth and dry well.
The base and container must not be soaked in water or other liquids, and should
only be cleaned using a damp cloth.
All manuals and user guides at all-guides.com
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Bimar (Italy). The pages
must be reproduced and folded in order to obtain a booklet A5
(+/- 148.5 mm width x 210 mm height). When folding, make sure
you keep the good numbering when you turn the pages of the
I/B. Don't change the page numbering. Keep the language
integrity.
6
Assembly page 6/24
A. On/Of wheel
B. Pilot light
C. Base with electrical lead
D. Stainless steel container