Switching On / Off; Fall Arrest - Hilti SL 6-22 Manual De Instrucciones Original

CAUTION
There is a risk of crushing fingers in the joint area When the lamp head is
being turned, there is a risk of the fingers being caught between the support
leg and the casing.
▶ Wear protective gloves.
The vertical pivot joint and the lamp head can be turned in either direction
along the axis. Do not attempt to force the lamp head past the end stops.
1. Unlock the vertical pivot joint with the locking switch to adjust the lamp
vertically.
2. Then turn the vertical pivot joint in the desired direction.
3. Lock the vertical pivot joint with the locking switch.
4. Turn the lamp head to the desired position to adjust the lamp horizontally.

5.5 Switching on / off

Whenever you engage the product on the universal hook or mount it on
a tripod, make sure that the product is secure.
1. Select a mode by repeatedly pressing the mode switch.
▶ Brightness 100 %
▶ Brightness 66 %
▶ Brightness 33 %
2. To switch the lamp off, press the mode switch and hold it down for at
least 1 second, until the lamp goes out.

5.6 Fall arrest

WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether
for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining
strap and the Hilti tool tether #2261970.
▶ Secure the retaining strap to the installation openings for accessories.
Check that it holds securely.
*2266228*
2266228 English 9