Cable Installation - Uline H-9931 Manual

CABLE INSTALLATION

WARNING! To reduce the risk of injury, always
wear proper eye protection marked to comply
with ANSI Z87.1. Always wear leather gloves over
latex/rubber gloves to avoid entanglement.
The cable is under pressure and can uncoil
unexpectedly. Cable tip may be sharp.
Remove the cable for cleaning after each use.
Different size and types of cables are available
for different applications.
TO REMOVE THE CABLE
1. Remove the battery pack and set the front handle
to the unlocked position by pulling it out, away from
the tool. (See Figure 1)
Figure 1
2. Remove the four screws from the drum cover.
WARNING! The cable is under pressure and
can uncoil unexpectedly. Keep pressure on the
cable so it does not uncoil.
3. Hold the cable firmly from under the drum cover
while pulling off the front handle. The inner drum will
be exposed.
4. Feed the cable carefully back through the front
handle and tuck it into the inner drum. Set the front
handle aside. (See Figure 2)
Figure 2
PAGE 2 OF 22
ASSEMBLY CONTINUED
5. Remove the inner drum with cable from the tool.
(See Figure 3)
6. When cleaning or maintaining the cable, carefully
uncoil the cable from the inner drum. Follow the
cleaning instructions under "Maintenance."
TO INSTALL THE CABLE
1. Remove the battery pack and set the front handle
to the unlocked position by pulling it out, away from
the tool. (See Figure 1)
2. Fully wind the clean, dry cable into the inner drum in
the direction of the arrow.
3. Place the inner drum with cable back into the tool.
4. Carefully pull the cable tip out of the inner drum
and feed it through the front handle. (See Figure 4)
5. Place the front handle over the inner drum and
reinstall the four screws. Tighten securely.
6. Remove the protective tip cover from new cables
before use.
Figure 3
WARNING! The cable is under pressure and can
uncoil unexpectedly. Keep pressure on
the cable so it does not uncoil.
Figure 4
0122 IH-9931