Cleaning And Maintenance - cecotec BREEZECARE 2600 LIGHT SMART Manual De Instrucciones

ENGLISH
Press the timer button to select the desired runtime: 2, 4, 6 or 8 hours.
Press the LED light button to turn on the product's light.
If the device is not going to be used for some time, empty the tank. To do so, take the cover
off, tilt the product (tank and base together) and pour all the water out.
Fig. 4.
Warning: Do not exceed the maximum water level mark when adding water: 3.2L.
Remote control
All functions can be operated from the remote control.
Fig. 3.
1. LED light button
2. Humidification setting
3. Time decrease
4. Time increase
5. On/off button

4. CLEANING AND MAINTENANCE

Use a soft, damp cloth to clean the surface of the device.
Do not use detergent, scouring pads, chemically treated cloths, gasoline, benzene, alcohol,
thinner, or other solvents, as these can scratch and damage the tank and cause water
leakage.
Do not immerse the product in water or any other liquid.
If scale is built up due to the use of hard water, it is recommended to:
Use cold boiled water or distilled water.
Change the water in water tank more often to keep it fresh.
Make sure to pour out water from the water tank and dry the water basin before you store it
unused for a long time.
Clean the whole humidifier and make sure that all parts of the humidifier are dried completely
if it is supposed to be leaved unused for a long time.
5. TROUBLESHOOTING
30 BREEZECARE 2600 LIGHT SMART
Trouble Possible cause
The humidifier is not
plugged in.
The light indicator is off
Power cord is damaged.
when switched on
Humidifier is defective or
malfunctioning.
Humidifier is not turned on.
The light indicators is on
when switched on, but no
The set humidification level
mist comes out
is too low
Low water temperature.
Dirty water or water sitting
Humidifier produces small
too long.
amount of mist
The set humidification level
is too low
Water being used has a high
mineral content.
White dust appears around
the humidifier
Humidifier was not properly
cleaned after last use.
Mist is coming out from the Water tank is not positioned
base correctly.
There are apertures
Mist fog coming out from
between the nozzle and
around nozzle
water tank.
Not enough water in the
water tank.
Unusual noise
The device is not placed on
a stable surface.
ENGLISH
Solution
Plug the humidifier into a
powered electrical socket.
Stop using the device
immediately and contact the
Technical Support Service of
Cecotec.
Press the ON button.
Increase the humidity level.
Replace water in the tank.
Clean water tank, fill with
clear water.
Increase the humidity level.
Use distilled water with the
humidifier. If distilled water
is not available, use purified
or filtered water. Remember
to clean water tank at least
once a week.
Clean humidifier.
Turn off and unplug the
humidifier, then install the
water tank properly.
Reinstall the cover and check
if the nozzle is well plugged
in the cover.
Add water to the tank.
Place the device on a flat,
stable surface.
BREEZECARE 2600 LIGHT SMART 31