Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS REQUIRED:
2 pcs - P7 Puck Catcher with Sensors
1 pc - P8 Electronic Scorer
8 pcs - H3 Phillips Round Head Screw
3 pcs - H4 Phillips Flat Head Screw
3 pcs - AAA Batteries (Not Included)
STEP 3:
With the help of another adult, carefully lift and rotate table into upright position.
First, feed the sensors plug (White and Black) from Puck Catcher P7 through the end apron.
Next, use pilot holes provided to attach each Puck Catcher P7 using Phillips Round Head Screws
H3 as shown in FIGURE 3.
Next, use pilot holes provided to attach Electronic Scorer P8 and Bracket C1 using Phillips Flat
Head Screws H4 as shown in FIGURE 3.
Lastly, feed the Electronic Scorer P8 plugs through leg side panel and underneath support beams
as shown. Then connect the plug with the sensor plug (White-White and Black-Black) as shown.
Install 3 "AAA" batteries (not included) into electronic scorer.
CAUTION:
P7
All Rights Reserved
©
2
0
10
E
c s
a
a l
d
e
S
p
r o
and Lead Wires
.
C2
White
C3
Black
s t
P7
FIGURE 3
7
White
Black
C1
CAUTION:
F
r o
C
u
s
o t
m
r e
S
e
v r
c i
e
C
l l a
- 1
H3
P8
H4
888-996-2729
Publicidad
