Requirements On The Installation Location; Electrical Connection; Prior To First Use; Initial Operation - GRAFF WK350 Manual De Instrucciones

REQUIREMENTS ON THE INSTALLATION LOCATION

For safe and fault free operation of the unit, the following requirements of the installation location
have to be met:
The unit has to be placed on a solid, flat, horizontal, and non-slipping surface with a sufficient
●
weight-carrying capacity.
Make sure that the unit cannot topple over.
●
Choose the location in such a way that children cannot reach the supply line of the unit.
●
Do not place the appliance on hot surfaces, such as hotplates, or near them.
●
Never use the unit in the open, and store in a dry location.
●
The unit is not designed for installation in a wall or a built-in cupboard.
●
Do not set up the unit in a hot, wet or moist environment.
●
The socket has to be easily accessible so that the power cable can be removed easily in
●
case of emergency.

ELECTRICAL CONNECTION

For safe and fault-free operation of the unit, the following requirements have to be met during
the electrical connection:
Before connecting the unit, compare the connecting data (voltage and frequency) on the
●
type plate with those of your energy network. These details must correspond so that no dam-
age occurs to the unit. In case of uncertainty, contact a qualified electrician.
The socket has to be protected at least by a 10 amps circuit breaker.
●
Make sure that the power cable is not damaged and is not laid across hot surfaces or sharp
●
edges.
The connecting cable must not be stretched tightly.
●
The electric safety of the unit is ensured only when it is connected to a socket with protective
●
conductor installed correctly. Operation on a socket without protective conductor is forbid-
den. If in doubt, let the house installation check by a trained electrician. The manufacturer
shall not assume responsibility for damage which has been caused by absent or interrupted
protective conductor.

PRIOR TO FIRST USE

This unit brings water to the boil within a few minutes.
Fill the unit with clear cold water and re-boil it at 80° C in order to clean the unit. Pour out the
re-boiled water.

INITIAL OPERATION

Take the base station and wind up the cable as far as possible. The length of the supply line
●
which is not necessary can be wound up at the bottom of the base station.
Insert the plug into the socket.
●
Remove the lid.
●
Fill the electric kettle with a minimum of 0.5 litre of water. Do not exceed the maximum
●
24