Cleaning; Storage - Zipper Maschinen ZI-WP700TN Instrucciones De Servicio

14.3 Cleaning

The use of paint thinners, petrol, aggressive chemicals or scouring agents will dam-
age the plastic surfaces! Therefore, only use mild cleaning agents for cleaning! Make
sure that no water seeps into the unit!
Clean the unit after each use. Therefore wipe it with a clean, damp cloth or blow off dust
and material residues with compressed air at low pressure.

14.4 Storage

 - Disconnect the power plug
 - Store unused equipment in a dry, closed place out of the reach of children.
To extend the service life of the saw and ensure smooth operation, carry out the following
before storing it for a longer period of time:
 Clean the machine thoroughly.
 Treat all moving parts with an environmentally friendly oil.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-WP700TN
4. Loosen the fixing bolt to release the
ring end of the chain for stop pin.
5. Pull the stop pin out of the base
frame.
6. Insert the lock pin through the hole of
the saw blade cover to block saw
blade from rotating.
7. Loosen and remove the bolt M12x30
with the wrench packed with the ma-
chine. Remove the washer and front
clamping flange and take down the
saw blade.
Insert the new saw blade (observe
the direction of rotation!).
The assembly of the new saw blade is
done in reverse order.
NOTICE
Never use grease! Do not oil the engine!
MAINTENANCE
28