Basic Installation - Clarity XL40D Guia Del Usuario

Basic Installation

Install the backup batteries (optional) by removing the battery
Step 1:
cover as shown in
in
Figure 2.
Connect one end of the phone cord into the (square) LINE port
Step 2:
on the back of the phone; connect the other end of the phone
cord into your wall telephone outlet .
Connect one end of the (curly) handset cord into the handset jack
Step 3:
on the left side of your base; connect the other end of the handset
cord into the bottom of the handset . Place handset in cradle .
Connect the DC adapter cord into the (round) DC 9V 500MA
Step 4:
port on the back of your phone; plug the adapter into your wall's
electrical outlet .
IMPORTANT: Use only with Class (Classe) 2 power source .
Figure 1
Note: Remove battery cover using a thin object (like the tip of a
pen) to push down the tab shown by the arrow above.
When finished, lift handset to test . If you hear a dial tone, your telephone is
ready for use . If not, check all connections again .
If there is a power outage, the XL40D will maintain its full amplification for
up to 48 hours with four AA alkaline backup batteries (not included) .
8
All manuals and user guides at all-guides.com
XL40D INSTALLATION
Connect your telephone as shown
Figure 1.
Figure 2