Intended Use; General Safety Instructions - Evolution R18RCH-Li2 Instrucciones Originales

INTENDED USE

This charger is solely for the charging of
batteries listed in the Technical
Specification section.
WARNING: When using power tools,
observe the following basic safety
measures for the prevention of electric
shocks and the risk of injury and fire.
Please read all these instructions before
using this electric tool and please keep the
saftey instructions.

GENERAL SAFETY INSTRUCTIONS

Careful handling and use of battery
devices
• Charge the batteries only in
chargers that are recommended
by the manufacturer. If a charger
that has been designed for a
particular type of battery is used to
charge other batteries, there is a risk
of fire.
• In the power tools, use only
the batteries designed for the
purpose. The use of other batteries
may result in injuries and risk of fire.
• Keep the unused battery away
from paper clips, coins, keys,
nails, screws and other small
metal objects, which could cause
bridging of the contacts. A short
circuit between the battery contacts
may cause burns or fire.
• If used incorrectly, liquid may
leak from the battery. Avoid
contact with this. In the event of
accidental contact, rinse off with
water. If the liquid gets into eyes,
seek medical assistance. Leaking
battery fluid may cause skin irritations
or burns.
• Do not use damaged or altered
batteries. Damaged or altered
batteries can be unpredictable and
lead to fire, explosion or risk of injury.
• Do not expose batteries to fire
or elevated temperatures. Fire or
temperatures over 130 ° C can cause
an explosion.
• Follow all instructions for
charging and never charge the
www.evolutionpowertools.com
battery or the battery powered
tool outside the temperature
range stated in the operating
instructions. Incorrect charging
or charging outside the permitted
temperature range may destroy the
battery and increase the risk of fire.
When the charger is in use it
•
must be supervised. If there is
any evidence of overheating then
immediately disconnect the charger
from the power supply.
• If gas or smoke is emitted from the
battery during charging switch off
the power supply and move to a
well vented area.
• Always disconnect battery
charger and remove battery from
charger when the charging is
complete.
• Always charge the battery pack
between temperatures 5°C to
40°C. Ideal charging temperature is
18°C to 24°C.
WARNING: Ensure the supply is the same
as the voltage given on the rating plate
for the charger. The charger is fitted with a
two-core cable and plug. Remove the mains
plug from socket before carrying out any
adjustment or servicing.
Service
• Never repair damaged batteries.
All battery repairs should be carried
out by the manufacturer or authorised
customer service centres only.
SPECIFIC SAFETY INSTRUCTIONS FOR
BATTERY OPERATED TOOLS
• Ensure that the device is switched
off before inserting the battery.
Inserting a battery into a power tool
that is switched on may result in
accidents.
• Recharge the batteries indoors
only because the battery charger is
designed for indoor use only.
• To reduce the electric shock
hazard, unplug the battery charger
from the mains before cleaning the
charger.
• Do not subject the battery to
4