Publicidad
Idiomas disponibles
Idiomas disponibles
7.
Attaching Bottom Brackets:
Position the bottom rail brackets to the ends of
the bottom of the bottom rail (side opposite the
one with the routed holes.) Screw into rail with
provided #10 x 1" screws (Fig. 5).
NOTE:
Within the Pro Rail bracket kit (model
#73013131), the two bottom rail brackets are
the larger ones.
8.
Install Bottom Rail:
a. Slide bottom rail in between posts and rest on
top of wood spacer blocks.
b. Screw bottom rail brackets into post (routed
hole side of rail, facing upwards) with provided
#10 x 1" screws (Fig. 6).
c. Place bottom rail gaskets at ends of the
installed bottom rail if desired, to cover any
gaps created during installation.
d. Remove/discard the temporary spacer blocks.
9.
Install Balusters:
Slide balusters into the routed holes of the bottom
rail (Fig. 7). Lock tabs on balusters must face the
outer edge of routed holes.
10.
Install Top Rail Brackets to Post:
a. Measure up 28
make a mark. This will be the location of the top
of the bracket (Fig. 8).
b. Using
screw holes into post. Drill through bracket
hole, vinyl post jacket, and wood or steel post
and loosely install rst #10 x 2
c. Repeat drilling process for remaining screws,
and tighten all screws.
11.
Install Top Rail:
a. Attach top rail to balusters: Begin at one side of
rail and align rst baluster with the rst routed
hole on the bottom side of the top rail and
snap top rail into position. Continue down the
line of balusters installing balusters into top rail.
b. Position the top rail brackets at the ends of the
underside of the top rail. Screw into rail with
provided #10 x 1" screws.
c. Place top rail gaskets at ends of the installed
top rail, if desired, to cover any gaps created
during installation.
12.
For Angled Installations:
Top and bottom rail should be cut to appropriate
angle and length to t tightly between posts. Top
and bottom rail brackets should be attached at the
same angle as rails (Fig. 11).
4
⁄
⁄
⁄
⁄ " from top of bottom rail and
7
7
7
8
8
⁄
⁄
⁄
⁄ " drill bit, pre-drill top rail bracket
5
5
5
32
32
⁄
⁄ " screw (Fig. 9).
⁄
⁄
1
1
1
2
2
Bottom Bracket
Bottom Bracket
Underneath
Underneath
Bottom Rail
Bottom Rail
Fig. 8
28
/
/
"
7 8
7
7
Fig. 5
Fig. 6
Fig. 7
Fig. 9
Fig. 10
Fig. 11
Publicidad
