Hortensus HOR-MANTER250 Manual De Usuario página 72

Rain impermeability: Acrylic and polyester sun protection awning materials are
impregnated with water-repellents and at a minimum tilt of 14 degrees will withstand a
light, short rain. In stronger or longer rain, awnings must be retracted to avoid damage.
Awnings that are rolled up wet should be extended again as soon as possible for drying.
Ripples in the seam, stitch and panel areas are caused by multiple layers of the fabric
and various winding strengths in the roller tube. Fabric tension thus caused can cause
ripples (e.g. waffle or herringbone patterns).
The fabric's yarn need not be the same color as the part of the fabric that contains the
seam.
(Excerpt from: Important consumer information: product characteristics of awning fabrics of
the Federal Association of Technical Textile Fabrication e. V. BKTex).
Maintenance
Regular maintenance will not only help to keep a long durability but is also important for your
own and the safety of other people.
Examine regularly if wall brackets are tight.
Examine the gear box once in half a year. If you find any damages stop using the awning
until gear box has been repaired or renewed.
Examine the bolts and nuts once in half a year, fasten them if loose or lax.
Stop using the awning immediatly if is has been damaged or it is not tighten properly.
Please contact an authorized service centre for repair.
Normally it is not necessary to lubricate moving parts of the awning. However, if it will be
come necessary on day do not use lubricants that are based on petroleum.
Use a straw attached to the spray nozzle. Lubricate generously the area between the end
of the roller tube and the end bracket (pivot pin). Take care not to overspray on the fabric
material.
Cleaning
Over time, dust and dirt will collect on the frame and will require periodic cleaning to maintain
its appearance.
A mild spray cleaner or water/detergent mixture may be applied to the frame and then wiped
clean. In most situations it should not be necessary to lubricate the moving component parts
of your awning.
Clean the fabric once in half a year and replace once in two years.
Always use a natural soap for cleaning. Water should be cold to lukewarm. Let the fabric dry
completely. Do not use heating appliances e. g. hairdryer for drying, only let it dry by natural
air.
Storage
When you do not want to use the awning for a longer period of time it is recommended to
take the awning out of the brackets and store it.