Technical Specifications - stayer SP L20 Manual De Instrucciones

gb
it, remove the gun from the hose and then unscrew the
lower nut of the gun, exposing the internal filter.
After cleaning the filter, put it back into the gun and tighten
the nut firmly to make sure there are no leaks.
When the battery is no longer operative, please refer to
an authorised aftersales service agent for Stayer power
tools.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an aftersales service centre for Stayer
power tools.
TRANSPORT
he contained lithiumion batteries are subject to the
Dangerous Goods Legislation requirements. The user
can transport the batteries by road without further
requirements. When being transported by third parties
(e.g.: air transport or forwarding agency), special
requirements on packaging and labelling must be
observed. For preparation of the item being shipped,
consulting an expert for hazardous material is required.
Dispatch batteries only when the housing is undamaged.
Tape or mask off open contacts and pack up the battery
in such a manner that it cannot move around in the
packaging. Please also observe possibly more detailed
national regulations.
DISPOSAL
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into house-hold
waste!
According the European Guideline 2012/19/EU for
Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that a
re no longer usa-ble must be collected separately and
disposed of in an environmentally correct manner.
Battery packs/batteries:
Li-Ion:
Please observe the instructions in section
"Transport". Do not dispose of battery packs/
batteries into household waste, fire or water.
Battery packs/batteries should be collected, recycled or
disposed of in an environmental-friendly manner.
Only for EC countries:
Defective or dead out battery packs/batteries must be
recycled according the guideline 2006/66/CE.

TECHNICAL SPECIFICATIONS

= Battery
= Voltage
= Battery power
= Charging time
= Working pressure
= Sound power level = Sound pressure level
L
PA
= Sound pressure level
L
WA
= Flow rate
= Tank capacity
= Weight
= Vibration
The values given are valid for nominal voltages [U]230/240
V-50/60 Hz - 110/120 V - 60Hz. For lower voltage and
models for specific countries, these values can vary.
INFORMATION ON NOISE AND VIBRATIONS
Wear hearing protection helmets!
Measured values established in accordance with
EN 62841-1.
The technical specifications indicated here are
understood within certain tolerances (in accordance with
the standards currently in force).
- 14 -