Johnson Controls PG9350SL Manual Del Usuario

User manual
Detector features
•
Battery saving function
•
IP65 waterproof rating (Not evaluated by UL)
•
4-channel beam frequency selector
•
Environmental disqualification circuit for configuring behavior in adverse weather conditions
•
Tamper function
•
Outdoor detection range of 350 ft
Introduction
The PG9350SL is a PowerG wireless photoelectric beam detector that provides protection for outdoor perimeters.
Warning: Failure to follow the instructions provided with this device, or improper handling, may cause death or
serious injury.
Safety information
Warnings
•
Do not use the product for purposes other than the detection of moving objects such as people and vehicles.
•
Do not use the product for unintended purposes, such as activating a shutter, which may cause an accident.
•
Do not touch the product when it is wet or touch the unit base or power terminals of the product with wet hands. It
may cause electric shock.
•
Do not pour water over the product as it may cause damage.
•
Never attempt to disassemble or repair the product. It may cause fire or damage to the devices.
•
Do not use batteries that have different levels of power remaining, that is, new and used batteries. Not observing
these guidelines may result in an explosion, leakage of electrolyte, emission of toxic gases, or other outcomes that
may be harmful to people and property.
•
When handling batteries, do not recharge, short circuit, crush, disassemble, exceed heat above 100°C (212°F),
incinerate, or expose the contents to water. Do not solder directly to the cell. Not observing these guidelines may
result in fire, explosion, or severe burn hazard.
•
Clean and check the product periodically for safe use. If any problem is found, stop using the product, and have
the product repaired by a professional engineer or electrician.
Box contents
Transmitter and receiver modules
Product documentation
Hardware pack
PG9350SL
Wireless photoelectric beam detector