Wet Nozzle - Dirt Hawg DH12000 Manual Del Usuario

12 Gallon Dirt Hawg 9/10/04

Wet Nozzle

To pick up liquids off a smooth surface,
use the 2-1/2" wet nozzle accessory
supplied with your wet/dry vac. To use this
nozzle, simply attach the nozzle to the end
of an extension wand.
Connect a second extension wand to the
first, and connect the 2-1/2" x 7' hose to
the extension wand.
Liquids may be picked up by dragging the
nozzle across the surface. The squeegee
will dry the surface as you vacuum.
Replacement rubber for the squeegee
nozzle may be obtained through the Dirt
Hawg Wet/Dry Vac Customer Service
Department. (Replacement service part
#822256). If the rubber becomes worn, it
may be flipped over for use on the
opposite side or replaced. To reverse or
replace the squeegee:
1. Lay the wet nozzle on a flat surface with
the round inlet opening facing up and
the two latches close to you as shown.
Latches
Removable
Insert
2. Using both hands, position each thumb
on the removable insert, (below the
latches) and two fingers of each hand on
each latch, lift and disengage the two
latches from the tabs on the nozzle body.
3. Gently pull the latches toward yourself
to remove the insert.
To reinstall the removable insert correctly,
follow these steps:
1. Place the removable insert on a flat
surface with the pins positioned upward
and the latches close to you as shown.
Place the rubber squeegee on the insert,
with the pins fitting through the matching
2:16 AM Page 12
Maintenance
(continued)
holes in the squeegee. (Make sure the new
working edge is located farthest from you.)
2. Using both hands, lower the nozzle body
onto the insert and squeegee with the
round opening of the nozzle closest to you.
With fingers on the far side and thumbs
holding the latches of the removable
insert, flip the nozzle over so the latches
are on the top and the round inlet opening
is facing away from you. Make sure the
squeegee stays on the insert pins.
3. Press down with each thumb below the
latching tabs until you see and hear the
removable insert snap into the nozzle
body. Snap the latches over the locking
Nozzle
tabs into their original position.
Body
4. Inspect the pins of the insert to make
sure they fit through the holes of the
squeegee and fit into the matching slots
in the nozzle body.
NOTE: If the pins are out of position, hold
the nozzle assembly with both hands and
gently twist in opposite directions. The insert
pins should snap into proper position.
Twist
Backward
The wet nozzle assembly is ready for wet
pickup use.
12
Twist
Forward