Publicidad
Idiomas disponibles
Idiomas disponibles
CUTTING AND C
Installation of the cutter(1)
Install the table to the cutter
base with provided screws and
bolts as shown.
Warning: Do not put your
fingers against the sharp edge
of the blade at any time.
Installation of the cutter (2)
Pull up the lock pin on the
aluminum handle as show and
insert the handle base into the
handle as show.
Warning: Do not put your
fingers against the sharp edge
of the blade at any time.
Straight Cutting
Insert material between the
cutting blade and the base,
flush with the gague
attachment as shown and
hold the material then push
handle down to complete a
cut.
Warning: Maintain control
of the handle. Do not allow
handle to slam back after
making a cut.
3
Publicidad
