Unpack The Machine; Install The Spray Wand; Install The High Pressure Hose; Operation - GreenWorks GPW1501 Manual Del Operador

3.2

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.3

INSTALL THE SPRAY WAND

7
1. Push the end of the spray wand (7) into the trigger handle
(6) and rotate clockwise to secure.
2. Pull on the spray wand (7) to be certain it is properly
secured.
WARNING
Make sure that the connection has no leakage.
3.4 INSTALL THE HIGH PRESSURE
HOSE
9
8
1. Push and turn clockwise one end of the high pressure
hose (8) into the inlet coupler (9).
English
6
4
2. Install and tighten the other end of the high pressure hose
(8) onto the water outlet coupler (4).
4

OPERATION

WARNING
Make sure that all the connections are tight and have no
leakage before operation.
4.1 CONNECT THE WATER SUPPLY
TO THE MACHINE
For easy operation, please use a self-coiling garden hose (not
provided).
WARNING
When you operate the self-coiling hose, make sure that the
hose has no blockage.
WARNING
• The water supply must come from the water main
• Do not use hot water
• Do not use water from ponds or lakes
WARNING
Do the local regulations when you connect the garden hose
to the water supply. Direct connection through a receiver
tank or backflow preventer is usually permitted.
CAUTION
Inspect the filter in the water inlet connector before you
connect the garden hose
• If the filter is damaged, do not use the machine until the
filter is replaced.
• If the filter is dirty, clean the filter.
10
1. Uncoil the garden hose (10).
2. Let the water flow through the garden hose (10) for 30
seconds.
3. Turn the water supply off.
4. Install and tighten the end of the garden hose (10) to the
water inlet (3) connector.
7
3
EN