Publicidad
EN
This manual contains important information that should be kept
for future reference.
For domestic use only.
Self-assembly.
Warning! Keep children away from the assembly area. Leave the
plastic bags out their reach. The small parts pose a choking
hazard.
Materials
Structure: chipboard oak veneer, clear matt lacquer (Quercus
robur, origin: Croatia).
Ladder and support: steel.
Assembly Instructions
In order not to lose components, do not throw the packaging
before completing the full assembly.
Before beginning assembly, identify all the components using the
manual.
This product must be assembled by an adult.
Plan to assemble the product as close as possible to where it will
be installed.
Assemble on a clean, flat surface.
Do not use an electric screwdriver.
The product cannot be assembled more than one time.
Warning! Before drilling, make sure that no pipes or cables will
be present in the drilling area. Fix the product to the wall to
ensure its stability. Use the type of screws and wall plugs for the
supporting material.
With time, the bindings can lose their effectiveness. Regularly
check the tightening of screws. If necessary tighten.
Recommendations for use
This product is designed for indoor use only.
Do not climb the product.
Do not overload shelves.
Check the proper assembly before each use.
The wood-based products, particle board, painted, varnished and /
or lacquers may emit an odor when opened. This smell disappears
after a few weeks if the room is properly ventilated.
Maintenance
Part(s) of wood
Remove dust regularly with a dry cloth.
Clean with a soft, damp cloth. Then wipe with a clean dry cloth.
Wipe up spills immediately with a clean, dry cloth.
To prevent scratching, do not use a sponge or recurrent grains
detergent.
Do not use abrasive products.
The use of special products for the wood is not necessary or
recommended.
Do not place the product near a heat source (radiator, fireplace ...)
nor a moisture source. Heat and humidity may damage the
product.
In order not to damage the surface, it is recommended not to
deposit hot items Wet directly.
Clean with movements in the direction of the wood fibers.
Clear scratches with a cloth soaked in red polish.
Metal components
Remove dust regularly with a dry cloth.
Clean metal parts with a soft cloth dampened with neutral pH
detergent. Then wipe with a dry cloth to prevent spotting.
Clean chrome surfaces, stainless steel, brass or iron with special-
ized products. Always carefully follow the instructions for use
accompanying maintenance products.
Do not use solvent.
Do not oil the metal.
Do not use abrasives.
Camus – 04/2022
Keep the label with lot number, it may be useful in case of
complaint.
If you have any comments or suggestions regarding this product,
assembly instructions or service received, please enquire at your
nearest store or contact us on our website at: www.habitat-
design.com or write to this address: HABITAT, 70 AVENUE
VICTOR HUGO, 93300 AUBERVILLIERS FRANCE.
The packaging elements are to be sorted out according to local
requirements. Make the right sorting choice and give them a
second life!
By sorting out this manual you contribute in preserving the envi-
ronment. This manual can still be found on www.habitat-
design.com.
1
Publicidad
