Athena GET WIFI-COM HONDA Guia página 3

C. INSTALLATION OF GET WIFI-COM HONDA
WIFICOM HONDA INSTALLATION FOR:
Honda CRF 250 R M.Y. 2017 and older versions
Honda CRF 450 R M.Y. 2016 and older versions
1.
Remove the left radiator
shroud to ease WiFi-COM
HONDA installation.
2.
Find the OEM diagnostic
four-pole connectors situated
in the front left side of the
bike: if necessary, check the
workshop manual to find
the connectors. Unplug the
OEM cables.
3.
Connect the male
and female WiFi-COM
HONDA connectors to the
female and male red four-
pole connectors of the
motorcycle.
EN
GET
OEM WiFi-COM HONDA
4
ATTENTION:
- Always make sure that the connectors are correctly
associated; when connecting them, a "click" is heard
that indicates they are connected correctly.
- If you want to keep the WiFi-COM HONDA
installed on the bike, fix it in a well-protected point
on the motorcycle. We suggest installing it on the
top of the front fork and fastening it with zip ties.
Keep the WiFi-COM HONDA away from spark plug
cables, coils, and sources of excessive heat.
- After the installation, check that the wiring does
not obstacle the free movement of the handlebar
in both directions nor interferes with the moving
components of the motorcycle (e.g., transmission)
or with the rider (e.g., the boot area).
4.
Re-install the left
radiator shroud.
WIFICOM HONDA INSTALLATION FOR:
Honda CRF 250 R M.Y. 2018 and newer versions
Honda CRF 450 R M.Y. 2017 and newer versions
Honda CRF 250/450 L or RL
1.
Remove the left radiator
shroud to ease WiFi-COM
HONDA installation. On
Honda CRF 250 / 450 L and
RL the connectors are under
the seat. Proceed removing it.
5 EN