Publicidad
Idiomas disponibles
Idiomas disponibles
1605A000E8.qxp_HSGP-01 6/25/20 11:13 AM Page 7
with a USB cable provided by Dremel.
Use of other USB cables may result in
tool and property damage and personal
injury.
Your Dremel HSGP-01 does not come
completely charged from the factory. Be
sure to charge tool prior to initial use.
-
Insert USB cable 9 into USB port of
power adapter 10 (Fig. 1).
-
Plug power adapter 10 into standard
power outlet.
-
Plug micro USB plug into Micro USB
port 7.
The LED indicator 5 will blink green
indicating that the battery is charging.
When the charging process is complete,
the LED indicator will be continuously lit
green.
It is normal for the handle of the tool to
get warm during charging.
Note: The tool cannot be used during
the charging process.
When the battery is fully charged,
disconnect the Micro USB end of the
cable 9 from the tool.
Unplug the power adapter from the
power outlet (unless you are charging
another tool).
IMPORTANT CHARGING NOTES
-
Lithium-ion battery will hold its
charge while in storage for up to 2
years so it's always ready when you
Preparing for gluing
The bonding locations must be clean,
dry and free from grease.
The materials to be glued together and
the work surface must not be easily
ignited or flammable.
Test whether heat-sensitive materials
are suitable beforehand on a sample
workpiece.
Charging the Tool
Charge
Dremel
HSGP-01 Glue Pen
Operating Instructions
need it.
-
The power adapter was designed to
fast charge the battery only when the
battery temperature is between 41˚F
(5˚C) and 104˚F (40˚C).
-
A substantial drop in operating time
per charge may mean that the battery
pack is nearing the end of its life and
should be replaced. To replace an old
battery, contact Dremel customer
service at 1-800-4-DREMEL. The
Dremel Service Center can install a
new battery and ship it back to you
within 48 hours of receiving your tool.
-
If battery does not charge properly:
a.
Check for voltage at outlet by
plugging in some other electrical
device.
b.
Check to see if outlet is connected
to a light switch which turns power
"off" when lights are turned off.
c.
Check USB terminals for dirt.
Clean with cotton swab and
alcohol if necessary.
d.
Check to see if USB cable is
properly connected to the tool and
the power adapter.
e.
If you still do not get proper
charging, send tool and power
adapter to your Dremel Service
Center.
Note: Use of power adapters or battery
packs not sold by Dremel may void the
warranty.
The ambient temperature and the
workpieces to be glued must not be
colder than 41 °F (+5 °C) and not
warmer than 122° F (+50 °C).
Materials that cool the adhesive down
quickly should be warmed first with a
hot air gun.
-7-
Publicidad
