Commissioning, Operation - Baxi Quantum MAXI Instrucciones De Instalación Y Funcionamiento

• The connecting cable is to be laid in such a way that it can
under no circumstances come into contact with the pipe
and/or the pump and motor housing.
• The switching of the pump using triacs / solid-state relays
must be tested on a case-by-case basis.
CAUTION: Voltage pulsing during phase angle control
or external control can cause damage to electronic
components.
• Only operate the pump with sinusoidal AC voltage as
stated on the rating plate.
• The switching of the pump using triacs / solid-state
relays must be tested on a case-by-case basis.
5 Commissioning/operation
WARNING: Depending on the pump or the system
operating conditions (fluid temperature), the entire
pump can become very hot. There is a risk of burns
upon coming into contact with the pump!
Commissioning by qualified personnel only!
5.1 Operation
The pump is operated using the operating button.
Turning
Selection of the control mode and setting of the delivery
head or speed stage.
5.2 Venting
• Fill and vent the system appropriately.
• The pump rotor space vents automatically after a short time
in operation. This may cause noises. If necessary, switch
off and on again repeatedly to speed up the venting pro-
cess. The pump will not be harmed by dry running for short
periods.
Installation and operating instructions
English
39