Better Packages PS2A Instrucciones De Uso página 16

Single Length Cutting
Pre-set the desired length of tape by pressing the "CM" or "MM" setting. Press the
"Dispense" keypad and the tape will be dispensed and cut. Remove tape.
Setting Tape Length
When the unit is turned on, it will automatically show "020" millimeters on the LED
display. You are now ready to program the tape lengths you desire.
1. To increase the millimeter length of tape, press the "MM" key for each
incremental millimeter you wish to dispense.
2. To increase the centimeter length of tape, press the "CM" key for each
incremental centimeter you wish to dispense.
3. If you wish to start over, simply press the "20" key and the LED will reset at 20
millimeters.
Auto Setting and Auto Cut Setting
ALWAYS KEEP FINGERS AWAY FROM THE BLADE AS IT CUTS TAPE
If you wish to automatically dispense tape at a pre-set displayed length, follow these
instructions.
1. Set the desired length of tape by using the "CM" and "MM" key pads and then
press the "DISPENSE" key pad.
2. Each time the "DISPENSE" key pad is pressed the same length of tape is
dispensed and cut. Simply remove the tape from the exit area and press
"Dispense" for your next length of tape.
3. To automatically dispense and cut tape at an exact preset length, simply lift
the switch on the front of the exit area. Once this switch is engaged, the tape
will automatically dispense the preprogrammed length and cut the tape. Once
the tape is removed, a new length of tape will be dispensed. This will continue
until the switch is pulled downward into the OFF position. Different degrees
of light intensity may affect the auto dispensing feature. If this occurs,
"CM" Centimeter Key
"MM" Millimeter Key
"20" Reset Key