Publicidad
Step 11
Carefully lay your unit onto its BACK, and place the FRAME around
å
your unit as shown.
Fasten the END FRAMES (J and K) to the BOTTOM BRACES (M).
å
Tighten eight 1/2" HEX HEAD SCREWS (17) using the L-WRENCH (10).
NOTE: You should start each SCREW a few turns before completely
å
tightening any of them.
Fasten the END FRAMES (J and K) to the TOP (A). Tighten two
å
1-15/16" HEX HEAD SCREWS (11) using the L-WRENCH (10).
Completely tighten the SCREWS in the BACK BRACE (O).
å
1-15/16" HEX HEAD SCREW
(2 used for the TOP)
O
Page 16
10
11
J
A
M
M
429322
K
17
1/2" HEX HEAD SCREW
(8 used for the BRACES)
www.litterbox.com/support
Publicidad
