Publicidad
EN
UNIVERSAL GAMING HEADSET
(L)
Game Mute
Game Volume
Rising tone = unmuted
Falling tone = muted
Power LED
Solid = ON/Connected
Slow Blink = Searching
Power Button
Fast Blink = Battery Low
USB Charging Port
Mobile/Xbox Input
Microphone Port
CABLES/PARTS
Xbox Chat Cable/
Xbox 360
USB Charging
Mobile 3.5mm Cable
Chat Adapter
Cable
Boom Mic
Mic Port Cover
All manuals and user guides at all-guides.com
(R)
Chat Volume
BASE STATION
Status LED
Solid = ON/Connected
Slow Blink = Searching
Optical
Cable
CHARGING
Connect the small end (micro-USB) of the charging cable to the
headset. Connect the other end to a USB port. The LED on the
headset will pulse while charging and turn solid when charging
is complete.
Microphone Mute
Rising tone = unmuted
Falling tone = muted
LED on boom mic
illuminates when muted.
When battery has less than 15%
power remaining, unit beeps twice
every 10 minutes.
CONNECTING TO CONSOLE
For: PS4, PS3, Xbox One, and Xbox 360
EQ Preset Select
1 beep for Normal
2 beeps for Bass Boost
3 beeps for Treble Boost
STEP 1.
Connect the wide end of the optical cable to
the optical port on the rear of the Console. Early
Xbox 360 Consoles may require an HDMI Audio
Adapter (not included).
PLA YSTATION 4 SETUP
1.
Go into Settings > Sound and Screen > Audio Output Settings > Primary
Output Port and select 'Digital Out (Optical)'.
2.
Make sure that only 'Linear PCM 44.1kHz and 'Linear PCM 48kHz' are checked.
3.
Go into Settings > Audio Output Settings > Audio Format (Priority) and select
'Linear PCM.'
4.
Go into Settings > Devices > Audio Devices and set both the 'Input Device' and
'Output Device' to 'USB Headset(Lucid Sound LS30).
Optical Input
5.
Set the Output to Headphone to 'Chat Audio'.
6.
Set the 'Volume Control (Headphones)' to maximum.
MICROPHONE
The LS30 includes an optional boom microphone.
When this microphone is removed, an internal
microphone is activated.
To connect the boom microphone, simply insert it
into the port on the bottom of the headset.
STEP 2.
STEP 3.
Connect the thin end of the optical cable to the
Plug the Base Station into a USB port on the Console.
optical port on the side of the Base Station.
PLA YSTATION 3 SETUP
1.
Go into Settings > Sound Settings > Audio Output Settings > Optical Digital.
2.
Make sure that only 'Linear PCM 2 CH. 44.1kHz' and 'Linear PCM 2 CH. 48kHz'
are checked.
3.
Go into Settings > Accessory Settings > Audio Device Settings and set the
'Input Device' and 'Output Device' to 'Lucid Sound LS30'.
EN
!
Publicidad
