Operation; Connection To The Vehicle - ANCEL HD601 Manual Del Usuario

Code Reader
2

Operation

2.1 Connection to the vehicle

You can connect the reader to the vehicle ECU via the
interface OBD II.
If the vehicle interface is 6/9 pin, please use the
transmission line to connect. One side of the
transmission line is connected to the vehicle interface,
and the other side is connected to the OBDII interface
of the code reader.
Caution: The operating voltage is between 9V-36V,
please make sure the output voltage of your vehicle's
diagnostic socket is 9V-36V.
Turn the ignition key of the vehicle to ON or start the
engine, then the code reader will start automatically.
9