Motor Safety Filter Cleaning; Exhaust Filter Changing - Titan T9200 Manual Del Usuario

MOTOR SAFETY FILTER CLEANING

Check motor safety filter occasionally and clean when dirty.
WARNING
Electrical Shock Hazard
Turn off and unplug vacuum cleaner from electrical outlet. Do not operate the vacuum
cleaner without the motor safety filter. Be sure the filter is dry and properly installed to
prevent motor failure and/or electrical shock.
1. Remove the bag as outlined in the BAG CHANGING (page 27-28) section.
2. Lift the rubber retainer and pull out motor safety filter as shown.
3. Wash filter in warm soapy water, rinse, then dry. Do not clean in dishwasher or install
while damp.
4. Replace the filter by sliding it back into place under the ribs in the bag cavity. Tuck filter
in so that it fits completely under the rubber retainer.
5. Replace the bag as outlined in the BAG CHANGING (page 27-28) section.

EXHAUST FILTER CHANGING

The exhaust filter cartridge must be replaced regularly. Replace the exhaust filter when the
entire surface area is covered evenly. The exhaust filter CANNOT be washed as it will lose
its dust trapping ability.
NOTE: Use replacement exhaust filter, see part number detail in REPLACEMENT PARTS
(page 7).
Rubber
Retainer
Rubber
Retainer
-29-