GYS POWER PACK 520 Manual Del Usuario página 12

Translation of the original instructions
2 / Use both DC 24 V / 2.5 A (3) and USB Type-C (10) inputs.
The POWER PACK 520 must only be charged by its charger.
1. Plug the charger cable into the corresponding input of the POWER PACK 520 : (3) or (10).
2. Connect the other end of the cable to the power source that will perform the charge.
3. Allow the POWER PACK 520 to charge and then disconnect it by performing the reverse operation.
For faster charging, both inputs can operate simultaneously with two different power sources.
3 / Using solar panels
The DC 24 V / 2.5 A input (3) can accommodate the energy from a solar panel.
1. Place the solar panel in direct sunlight without exposing the POWER PACK 520 to direct sunlight or moisture.
2. Connect the 3.5 mm output of the solar panel to the DC 24 V input port.
3. Allow the POWER PACK 520 to recharge and then disconnect it from the power supply.
4 / Using a car charger
1. Connect the car charger cable to the DC 24 V / 2.5 A input (3).
2. Plug the other end of the car charger cable into the car's 12 V cigarette lighter socket.
In case of failure, the icon corresponding to the input or output being used will flash on
the LCD display.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
12
POWER PACK 520
EN