Utilitech NF15-19UR Manual Del Usuario página 6

could result in an electric shock hazard.
10.This heater draws 12.5 amps during operation. To prevent overloading
a circuit, do not plug the heater into a circuit that already has other
appliances working.
11.CAUTION: It is normal for the plug to feel warm to the touch; however,
a loose fit between the AC outlet (receptacle) and plug may cause
overheating and distortion of the plug. Contact a qualified electrician to
replace loose or worn outlet.
12.To disconnect the heater, first turn controls to off, then remove plug
from outlet. Never pull by the cord.
13.Do not insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock or fire, or
damage the heater.
14.To prevent a possible fire, do not block air intakes or exhaust in any
manner. Do not use on soft surface, like a bed, where openings may
become blocked.
15.A heater has hot and arcing or sparking parts inside. Do not use it in
the areas where gasoline, paint, or flammable liquids are used or
stored.
16.Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or
injury to persons.
17.CAUTION: Always plug heaters directly into a wall outlet/receptacle.
Never use with an extension cord or reloadable power tap
(outlet/power strip).
18.The output of this heater may vary and its temperature may become
intense enough to burn exposed skin. Use of this heater is not
recommended for persons with reduced sensitivity to heat or an
inability to react to avoid burns.
SAVE THESE INSTRUCTIONS
5