Preset Panel; Power Supply; Bluetooth ® Connection - Montarbo L206 Manual De Uso

L206
15 LED PAIR
Status light for Bluetooth connection. It flashes while the mobile device is being paired,
®
while it is steady on when the connection is active.
16 STEREO LINK
Key for Bluetooth stereo pairing to a second L206.
®
17 LED STEREO LINK
Status indicator light flashing during the pairing to a second L206, and steady on once
the stereo streaming is ensured
18 LEVEL CH3
This knob adjusts the level of channel 2, turn it to the right to increase the level, to the
left to reduce it.
19 BATTERY STATUS LEDS
These LEDs indicate the battery status, and start to turn off progressively downwards
as the charge decreases
20 STATUS KEY
This key only works when the unit is off. While pressed, it allows displaying the current
battery charge status.
21 LED CHARGE
This LED indicates whether the device is charging or not.

PRESET PANEL

5
1 PRESET KEY
Press this key to select the desired preset. Press the key several times to scroll through
the selected preset, and the corresponding LED (STAND/GUITAR-MONITOR-SPEECH/
DESKTOP) lights up. For instrument connection or conference use, select GUITAR-
MONITOR-SPEECH; for further information refer to INSTALLATION EXAMPLES.

POWER SUPPLY

6
1 MAINS INPUT
IEC input socket with integrated mains filter. Each package includes the necessary
18
power supply cable, specific for your area. With the loudspeaker off, plug the power
supply cable into this socket. For your safety, never disconnect the earth plug.
2 FUSE
Protection fuse.
WARNING:
Only replace the fuse with one of the same type and with the same values.
If the fuse continues to blow, contact an authorised service centre.
3 POWER ON/OFF/CHARGE
Switch for switching the active loudspeaker on/off. In the CHARGE position, with power
supply cable connected to the mains, it recharges the internal battery. The battery is also
charged when the unit is operating (ON position), but much less quickly and efficiently.
1
BLUETOOTH CONNECTION
7 ®
- Make sure that the device to be paired to the loudspeaker is switched on and ready
for connection via Bluetooth . With the loudspeaker on, press the PAIR key to activate
®
Bluetooth pairing. The relevant green LED will flash.
®
- Check on your mobile device that the name of the loudspeaker (e.g. B108) appears
among the available devices.
- Select the loudspeaker model to pair your device. The perfect connection is indicated by
the corresponding LED, which remains steady on.
- Adjust the CH3 and MAIN levels for the desired playback volume of the selected tracks in
the paired device.
TO A SECOND LOUDSPEAKER
- On the first loudspeaker, already paired, press and hold the STEREO key for a few
seconds. The blue LINK LED starts flashing.
- Turn on the second loudspeaker and press the PAIR button, whose LED starts flashing.
Press then the STEREO key on the second loudspeaker: the relevant LINK led flashes for
a few seconds (NOTE: this last operation is required only the first time you pair the 2
loudspeakers). Once paired, both the LINK LED of the first loudspeaker and the PAIR LED
of the second loudspeaker remain steady on.
- Adjust LEVEL CH3 and MAIN of the second loudspeaker; the signal coming from the
source device is emitted by both loudspeakers.
User manual
2 3
19