Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Safety Instructions
•
DO NOT stand or climb on the shelving unit.
•
DO NOT drop heavy items on the shelving unit.
•
DO NOT place heavier items on the top of the
shelving unit than on the bottom.
•
DO NOT move the shelving unit when loaded.
•
Whilst all care has been taken to remove sharp
edges, care must be taken when cleaning or
handling the shelving unit to prevent risk of injury
from exposed metal edges.
Pack Contents
Note: Be sure to check all packaging
materials for any small parts that may
have come loose during transportation.
Lower pole section x 4
Upper pole section x 4
Shelf sleeve x 12
Cleaning, Care & Maintenance
•
Clean the shelving unit using warm soapy water.
•
Dry thoroughly after cleaning.
Assembly
1. Screw the upper poles to the lower poles. Ensure
the poles are securely screwed together.
Grooves
Small end (up)
Large end (down)
Fig. 1
Corner hole
Wire on top
Fig. 2
2
DC819_ML_A5_v2_20220412.indb 2
DC819_ML_A5_v2_20220412.indb 2
2. Select the required height for the bottom shelf.
3. Attach the sleeve to the pole at the required
4. Holding the shelf on its side, slide the pole
5. Once all four poles are through the corner holes
Shelf x 3
Instruction manual
6. Locate the next shelf by counting grooves on the
7. Lift the shelf up and onto the four poles, sliding
8. Repeat steps 6 and 7 for the remaining shelf.
9. If necessary, adjust the feet on the bottom of
Slip sleeve
Note: The upper poles have black plastic
caps at one end and a thread at the other.
Shelves can be attached at any of the circular
grooves, spaced 25mm (1") apart, along the pole.
position [Fig. 1].
Note: The bottom shelf should never be
more than 300mm (12") from the floor.
Shelves should never be situated more
than 450mm (36") apart.
through one of the corner holes [Fig. 2].
stand the shelving unit upright, and press the
bottom shelf firmly onto the sleeves [Fig. 3].
pole to the desired height. Attach a pole sleeve
and repeat for each pole [Fig. 4].
the shelf down upon the sleeves.
each pole to level the shelving unit.
Fig. 3
Fig. 4
2022/4/12 15:12
2022/4/12 15:12
Publicidad
