exceeded.
• Routing must always be carried out against the direction of rotation (bitrotation)
of the bit.
• The bit must be running at full speed before lowering into the work-piece.
• When operating the machine, take great care and always hold the router handles
rmly with both hands. Always provide for a secure footing when working.
• Beware of the reaction torque of the machine, particularly if the bit becomes
jammed in the workpiece.
• On completion of work, allow the machine to slide back to its initial position by
releasing the handle.
• Make yourself familiar with your working area and be alert for possible hazards,
which you might not hear due to machine noise.
• Caution: Allow for run down time of bit after turning router off. Wait for the
machine to come to a complete stop before removing from the work piece.
• Never slow the router down with your hands.
• Do not touch the bit immediately after operation; it may be extremely hot and
could burn you.
• Never stop the router by applying lateral pressure to the bit.
• Do not force the router. Your router will do a better job if you take it slowly.
• Avoid cutting nails and screws. Inspect timber and remove all nails and screws
before cutting.
• In the event of an electrical or mechanical malfunction, immediately switch o the
saw and disconnect the power lead from the mains supply.
3. DESCRIPTION
EN
148
1
Housing
2
Depth adjust knob(quick)
3
On/O switch
4
Air inlet
5
Spindle lock button
Right handle
6
7
Wing bolts
8
Depth indicator
9
Depth scale
10
Depth ruler
11
Plunge locking lever
12
Depth adjust knob
13
Variable speed dial
4. TECHNICAL DATA
Voltage
Frequency
Power input
No load speed
Collet
Plunge depth
L
(sound pressure)(K=3dB(A))
PA
L
(sound power) (K=3dB(A))
WA
Vibration value (K=1.5 m/s2)
5. ASSEMLY INSTRUCTIONS
Warning: Isolate the machine from the power supply before any
adjustments, maintenance or when changing router bits.
14
Safety button
15
Base
16
Dust extraction adapter
17
Parallel guide
18
Template guide
19
Long guide rods
20
Spanner
21
Centering position needle
22
Depth stop turret
23
Collet lock nut
230-240V-
50Hz
1200W
11500-30000/min
Φ8mm
52mm
86dB(A)
97dB(A)
6.23m/s2
149
EN