GreenWorks Pro CAB801 Manual Del Operador página 8

EN
2
3
This is a diagnostic charger. The
Charger LED Light (3) illuminates in
a specified order to show the current
battery status. They are as follows:
CHARGING PROCEDURE (LED
INDICATOR)
BATTERY IS CHARG-
ING
FULLY CHARGED
BATTERY IS TOO
WARM (REMOVE FOR
APPROX. 30 MINUTES
TO ALLOW TO COOL)
DEFECTIVE BATTERY
(REMOVE AND RE-
PLACE WITH A NEW
BATTERY)
Incorrect Defect Note:
English
1
1. Put the battery pack into the
2. Put the battery pack into the
3. Wait for 1 minute and put the
GREEN
BLINK-
ING
GREEN
RED
Low voltage charging
•
RED
BLINK-
ING
•
8
charger.
• If the status LED blinks
RED, remove the battery
pack from the charger for 1
minute.
charger again.
• If the status LED blinks
GREEN, the battery pack is
good.
• If the status LED stays
blinking RED, remove the
battery pack and disconnect
the charger.
battery pack into the charger
again.
• If the status LED shows
blinks GREEN, the battery
pack is good.
• If the status LED stays
blinking RED, the battery
pack is defective and it is
necessary to replace the
battery pack.
It can take 20 hours to fully
charge the battery if the battery
stored with no little no charger
for a long period of time.
If the battery is not used for a
long time, the charger will go
into the recovery mode, which