SOLAC CPB6100 Instrucciones De Uso página 8

6.When the iron is finished, place the iron in an
•
upright position or on the base when the iron
is interrupted
7.Disconnect the iron from the mains supply.
•
Pour of any remaining water and leave the iron
to cool off.
CONTINUOUS STEAM
Heating completed, temperature stabilized
•
2.Start steam switch, can choose large steam
•
or ECO steam at the same time, the two stalls
can be switched at any time. Fig. 5
SHOT OF STEAM
When the heating is completed, the tempe-
•
rature is stable.
Press the steam in two times quickly, and the
•
steam will start to explode in two seconds,
while the steam will flash for 3 seconds. Fig.6
SELF CLEANING
1.Please make sure there is enough
•
water in
the tank before cleaning
2.Please put the iron in a safe position before
•
cleaning to prevent people from being injured
by hot water during cleaning
3.After the heating is complete , the long press
•
the cleaning switch for 3 seconds , and the iron
enters the cleaning mode .The display on the
screen flashes and goes with the 3 sound of
bees. Fig. 7
4.Two minutes later, the buzzer rang three
•
times, indicating that the cleaning was
complete.
AUTO SHUT OFF
When the iron is stationary for more than 10
•
minutes, the iron goes out of power mode
The poweroff sign flashed on the display, ac-
•
companied by six buzzing sounds
Press the steam switch to restore the power
•
Irons will not be cut off during steam discharge
•
If you need stop the process switch off the
•
item
ANTI DRIP
This iron is equipped with a drip stop function:
•
the iron automatically stops steaming when
the temperature is too low to prevent water
from dripping out of the soleplate.
ANHYDROUS DETECTION (NO WA-
TER DETECTION)
In the course of working, if there is no water
•
in the water tank, the pump will automatically
stop working to protect the life of the pump
FAULTSREASONS
TIONS
IRON EMITS AN ODOR OR SMOKE
Iron gives off an odor when turned on for the
•
first time. Oils used during manufacture need
•
to be burnt off allow ten minutes for odor to
•
disappear.
•
IRON DOES NOT HEAT
The iron should be plugged into a 230 Volt ,
•
Whether the power switch is turned on
•
IRON DOES NOT STEAM
The water tank many be empty. Turn off the
•
steam regulator and add water. Allow the iron
•
to heat, and then set the turn on to the steam
•
setting.
•
IRON IS LEAKING
The temperature setting is too low to produce
•
steam. Shot of steam used too much, allow
•
iron to re-heat.
•
EN
AND SOLU-