Power Supply - Denver TC-14 Manual De Instrucciones

1
4
5
1 2 3
All manuals and user guides at all-guides.com
8 9 6 7 10 11
13 12
14
16
15
4 x 2 R14 • UM2 • C-CELLS
EN-2
English
CONTROLS
Top and front panels (See )
1
VOLUME
1
- adjusts volume level.
FUNCTION SELECTOR REPEAT
2
- selects the function CD,OFF or RADIO.
STEREO HEADPHONE JACK
3
- 3.5mm stereo headphone jack.
REPEAT
4
- repeats a track / CD/ program.
SEARCH ,
5
CD: - skips or searches a passage / track
backwards or forward.
6 PROGRAM
CD: - skips or searches a passage / track
backwards or forward.
CD DOOR
7
- lift here to open / close the CD door.
DISPLAY
8
- shows the CD functions.
STOP
9
- stops CD playback; erases a CD program.
PLAY/PAUSE
10
- starts or pauses CD play.
DIAL POINTER WINDOW
11
- shows the AM/FM dial frequency.
TUNING CONTROL
12
- selects FM/AM stations.
BAND SELECTOR ( FM • AM)
13
- selects FM / AM waveband.
)
Back Panel (See 1
TELESCOPIC ANTENNA
14
- pull out to improve to FM reception.
BATTERY DOOR
15
– to open battery compartment.
AC MAINS
16
– inlet for power cord.

POWER SUPPLY

Power Supply
Whenever convenient, use the power supply if you
want to conserve battery life. Make sure you remove
the plug from the set and wall outlet before inserting
batteries.
Batteries (not included)
Open the battery compartment and insert eight
batteries, type R-14, UM-2 or C-cells, (preferably
Alkaline) with the correct polarity as indicated by the
"+" and "–" symbols inside the compartment.
Batteries contain chemical substances, so they
should be disposed of properly.
Incorrect use of batteries can cause electrolyte
leakage and will corrode the compartment or cause
the batteries to burst. Therefore:
• Do not mix battery types: e.g. alkaline with carbon
zinc. Only use batteries of the same type for the
set.
• When inserting new batteries, do not try to mix old
batteries with the new ones.
• Remove the batteries if the set is not to be used
for a long time.
Using AC Power
1 Check if the power voltage, as shown on the type
plate located on the bottom of the set, corresponds
to your local AC power supply. If it does not,
consult your dealer or service centre.
2 Connect the power cord to the AC MAINS inlet and
the wall outlet. The power supply is now
connected and ready for use.
3 To switch off completely, unplug the power cord
from the wall outlet.
•Unplug the power cord from the wall outlet to
protect your set during heavy thunderstorms.
EN-3