After Use; Replacing Carbon Brushes - Makita 4100NS Manual De Instrucciones

Cortadora de mármol
Ocultar thumbs Ver también para 4100NS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Be sure to move the tool forward in a straight line
and gently. Forcing and exerting excessive
pressure or allowing the wheel to bend, pinch or
twist in the cut can cause overheating of the motor
and dangerous kickback of the tool.
When using a curving diamond wheel
(Accessory)
WARNING:
Do not obtain your desired cutting depth at a time
but make several adjusments by setting for the
small amount cutting depth
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may
result.

After use

Blow away dust from the inside of the tool by running the
tool at an idle for a while. Brush off accumulation of dust
on the base. Accumulation of dust in the motor or on the
base may cause a malfunction of the tool.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
1. Limit mark
1
1
2
009566
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
These
accessories
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Diamond wheels (Dry type)
Wrench 22
Hex wrench
7
1. Screwdriver
2. Brush holder cap
or
attachments
Only use
accessory or
are

Publicidad

Tabla de contenido
loading

Tabla de contenido